D-Link DGS-3612G - xStack Switch Reference Manual page 297

Allowas In Value (1-
10)
Default Originate
State
Route Map Name
EBGP Multihop (1-
255)
Weight (0-65535)
Update Source
IP Address
Peer Group Name
Advertisement
Interval (0-600)
Keep Alive (0-65535)
Hold Time (0-65535)
AS Origination
Interval (1-600)
Connect Retry
Interval (1-65535)
Click Apply to implement changes made.
®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
setting is Disabled. If no number is supplied, the default value of three times is used.
Enter an Allowas In Value between 1 and 10.
Enable or disable the default originate function. By default, this setting is Disabled.
Enter a Route Map Name of a maximum of 16 characters.
Enter the TTL of the BGP packet sent to the neighbor. For an EBGP neighbor the default
setting is 1. This means only direct connected neighbors are allowed.
Enter a value for weight. The valid range is from 0 to 65535. If this is not specified, the routes
learned through another BGP peer will have a default weight of 0. Routes sourced by the
local router have a weight of 3768. It cannot be changed.
Enter an interface to be used by BGP sessions for TCP connection. By default, this
parameter is not set.
BGP Neighbor Timer Settings
Enter the IP address of the neighbor to be configured.
Enter the peer group to be configured.
Enter the interval at which the BGP process sends update messages to its peer. The valid
value is from 0 to 600. If this value is set to zero, the update or withdrawn message will be
sent immediately. The default value for IBGP peers is 5 seconds and for EBGP peers it is 30
seconds. When the default check box is ticked, the neighbor specific advertisement interval
setting will be returned to the default setting.
Enter the interval at which a keepalive message is sent to its peers. If the two routers, that
build a BGP connection, have different keepalive timers, the smaller keepalive timer will be
unset. The valid value is from 0 to 65535. If the keepalive is set to zero, then the keepalive
message will not be sent out. By default, the timer is not specified. This neighbor specific
setting will follow the global setting.
The system will declare a peer as dead if not receiving a keepalive message until the hold
time. If two routers, that built a BGP connection, have different hold times, the smaller hold
time will be used. The valid value is from 0 to 65535. If the holdtime is zero, then the holdtime
will never expire. It is recommended that the holdtime value is three times that of the
keepalive timer. By default, the timer is not specified. This neighbor specific setting will follow
the global setting.
Enter the minimum interval between the sending AS origination routing updates. The valid
value is from 1 to 600. The default setting is 15 seconds.
Enter the minimum interval BGP sends TCP connect requests to the peer after a TCP
connection fail happens. The valid value is from 1 to 65535. The default setting is 120
seconds.
281