D-Link DGS-3612G - xStack Switch Reference Manual page 252

Enter the IP address of the default router for a DHCP Client. Users must configure at least one
Default Router
address here, yet up to three IP addresses can be configured for this field. The IP address of the
default router must be on the same subnet as the DHCP client.
Pool Lease Using this field, the user can specify the lease time for the DHCP client. This time represents the
amount of time that the allotted address is valid on the local network. Users may set the time by
entering the days into the open field and then use the pull-down menus to precisely set the time by
hours and minutes. Users may also use the Infinite check box to set the allotted IP address to
never be timed out of its lease. The default setting is 1 day.
This field is used to specify the Boot File that will be used as the boot image of the DHCP client.
Boot File
This image is usually the operating system that the client uses to load its IP parameters.
Next Server This field is used to identify the IP address of the device that has the previously stated boot file.
Click Apply to implement changes made.
To view the set parameters for configured DHCP Pool, click the View button of a configured entry in the DHCP Server Pool
Table in the Create DHCP Pool window, which will produce the following window:
®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 4- 79. DHCP Server Pool Display window
236