D-Link DGS-3612G - xStack Switch Reference Manual page 356

The following window is the CPU Access Rule Table for IPv6.
To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously created
rule, click the corresponding
Figure 6- 41. CPU Interface Filtering Rule Configuration window (IPv6)
The following parameters may be viewed or modified:
Parameter
Profile ID
Mode
Access ID (1-100)
Type
®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 6- 40. CPU Access Rule Table window (IPv6)
button. The following window is used for the CPU IP Rule configuration.
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 to 100.
Selected profile based on Ethernet (MAC Address), IP address, Packet Content or IPv6.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
340