Ac Power Cord Illustrations - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Appendix A Power Supply Specifications
Table A-20 6000 W Power Supply AC Power Cords (continued)
Locale
Japan, North America
(locking plug)
200–240VAC operation
Japan, North America
100–120VAC
1
operation
Power Distribution Unit
3
(PDU
Switzerland
1. The 6000 W power supply operating on two 110 VAC inputs delivers 2900 W.
2. When operating with 100–120VAC, you must use two AC power cords and the power supply output is limited to 2900 W.
3. The PDU power cable is designed for users who power their switch from a PDU. The end of the cable that plugs into the Catalyst 6500 series switch
chassis has a C19 connector; the other end of the cable that plugs into the PDU has a C20 connector.

AC Power Cord Illustrations

This section contains the AC power cord illustrations. Note that an AC power cord may be used with
several power supplies. See the power supply specifications tables for the correct AC power cord
illustrations for your power supply.
Figure A-17 CAB-AC10A-90L-AU=
Plug: SAA AS 3112
OL-5781-04
Power Cord
Part Number
CAB-AC-C6K-TWLK=
2
CAB-7513AC=
CAB-C19-CBN=
CAB-ACS-16=
Cordset rating: 10 A, 250 V
Length: 8 ft 2 in. (2.5 m)
Source Plug Type Cordset Rating
NEMA L6-20 16 A, 250 VAC
NEMA 5-20 16 A, 125 VAC
IEC 60320 C19 16 A, 250 VAC
IEC 60320 C20
SEV 5934-2 Type 23 16 A, 250 VAC
Connector: IEC 60320 C15
Catalyst 6500 Series Switches Installation Guide
AC Power Cord Illustrations
Power Cord
Reference
Illustration
Figure A-41
Figure A-33
Figure A-44
Figure A-42
A-47