Cisco 6509 - Catalyst Chassis Switch Installation Manual page 125

Chapter 3 Installing the Switch
Install the standard cable guide to the back panel by hooking the lip of the cable guide to the back panel.
Step 4
(See Figure
Install the two screws to secure the cable guide to the back plate. (See
Step 5
Note
Attach the interface cables to the modules, and route the cables through the cable guide.
Step 6
Install the front panel by hooking the top of the front panel over the cable guide.
Step 7
Tighten the two captive installation screws. (See
Step 8
Figure 3-15 Front Panel Installation
OL-5781-04
3-14.)
Before installing the front panel, attach the interface cables to the modules, and route the cables
through the cable guide. See the
information on attaching the interface cables.
FAN
STATU S
FAN
1
FAN
2
Captive installation screws
Installing the Cable Management System (Catalyst 6509-NEB-A Switch Only)
"Attaching the Interface Cables" section on page 3-28
Figure 3-15.)
Catalyst 6500 Series Switches Installation Guide
Figure 3-14.)
for
3-21