Cisco 6509 - Catalyst Chassis Switch Installation Manual page 116

Installing the Rack-Mount Kit
The optional cable guide installs on the front of the chassis and is secured with four M4 screws. To install
the L brackets, follow these steps:
Position one of the L brackets against the switch chassis side, and align the screw holes. (Use either the
Step 1
+ or the – holes.)
Secure the L bracket to the switch chassis with five M4 screws.
Step 2
Step 3 Repeat steps 1 and 2 for the other L bracket. If you used the + set of holes for the first L bracket, use the
– set of holes for the second L bracket.
To install the optional cable guide, follow these steps:
Step 1 Position the cable guide against the front of the chassis, and align the four screw holes as shown in
Figure
Secure the cable guide with four M4 screws.
Step 2
Figure 3-7
L bracket
M4 screws
Catalyst 6500 Series Switches Installation Guide
3-12
3-7.
Attaching L Brackets and Cable Guides: Catalyst 6509-NEB Switch
FAN
STATUS
Cable
guide
Chapter 3
L bracket
Installing the Switch
OL-5781-04