Installing the Cable Management System (Catalyst 6509-NEB-A Switch Only)
Replacing the Cable Guide
To replace the cable guides on the cable management system, perform these steps:
Step 1
Loosen the two captive installation screws on the front panel. (See
Figure 3-13 Removing the Front Panel
Remove the front panel, and set it aside.
Step 2
Remove the two screws that secure the cable guide to the back panel, and remove the cable guide by
Step 3
lifting it up and away from the back panel. (See
Figure 3-14 Removing the Cable Guide
Catalyst 6500 Series Switches Installation Guide
3-20
FAN
STATU S
FAN
1
FAN
2
Captive installation screws
STATUS
Figure
3-14.)
FAN
FAN
1
FAN
2
Chapter 3
Installing the Switch
Figure
3-13.)
OL-5781-04