Removing and Installing the Fan Assembly
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
Warning
fan blades completely stop before you remove the fan tray. Statement 258
To remove the existing fan assembly, follow these steps:
Locate the fan assembly as follows:
Step 1
See
•
left of the module cage.)
See
•
cage.)
See
•
left of the module cage.)
See
•
left of the module cage.)
See
•
See
•
module cage.)
Note
See
•
Loosen the two captive installation screws by turning them counterclockwise.
Step 2
Grasp the fan assembly with both hands, and pull it outward; rock it gently, if necessary, to unseat the
Step 3
fan assembly power connector from the backplane.
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the fan
Caution
blades stop completely before you remove the fan tray.
Step 4
Pull the fan assembly clear of the chassis, and put it in a safe place.
Catalyst 6500 Series Switches Installation Guide
4-58
Figure 4-49
for the Catalyst 6503 and Catalyst 6503-E switches. (The fan tray is located to the
Figure 4-50
for the Catalyst 6504-E switch. (The fan tray is located to the left of the module
Figure 4-51
for the Catalyst 6506 and Catalyst 6506-E switches. (The fan tray is located to the
Figure 4-52
for the Catalyst 6509 and Catalyst 6509-E switches. (The fan tray is located to the
Figure 4-53
for the Catalyst 6509-NEB switch. (The fan tray is located above the module cage.)
Figure 4-54
for the Catalyst 6509-NEB-A switch. (The two fan trays are located above the
On Catalyst 6509-NEB-A switches equipped with the optional cable management system, you
must first loosen the two captive installation screws located at the top of the cable management
system and fold the cable guide down to access the fan assembly. (See
Figure 4-56
for the Catalyst 6513 switch. (The fan tray is located to the left of the module cage.)
Chapter 4
Removal and Replacement Procedures
Figure
4-55.)
OL-5781-04