Securing the AC Power Cord (Optional)
Securing the AC Power Cord (Optional)
Make a loop in the power cord and thread it through the power cord retainer. Connect the power cord to
the power supply.
Figure 4
Connecting the StackWise Cables
You can stack the Catalyst 3850 switch with other Catalyst 3850 switches. Before connecting the
StackWise cables, review the "Planning a Switch Data Stack" section in the Catalyst 3850 Switch
Hardware Installation Guide.
Always use a Cisco-approved StackWise cable to connect the switches.
To connect the cable to the StackWise port on the switch rear panel:
Make sure that the Cisco logo is oriented at the top-side of the connector as shown in the illustration.
Step 1
Align the connector and connect the StackWise cable to the StackWise port on the switch rear panel and
Step 2
finger-tighten the screw (clockwise direction).
Connect the other end of the cable to the port on the other switch and finger-tighten the screw. Avoid
Step 3
overtightening the screws.
Catalyst 3850 Switch Getting Started Guide
14
Securing the AC power cord
A C O K
A C
1- 71 5W
P W R -C
P S O K
A C O K
A C
1- 71 5W
P W R -C
P S O K
OL-26778-02