Cisco 6509 - Catalyst Chassis Switch Installation Manual page 246

3000 W AC-Input Power Supply
Table A-15 3000 W Power Supply Specifications (continued)
Specification
Power supply output
Front panel power connector
Output holdup time
Heat Dissipation
Front panel LEDs
INPUT OK
•
FAN OK
•
OUTPUT FAIL
•
42V OK
•
Weight
Catalyst 6500 Series Switches Installation Guide
A-36
Appendix A
Description
100/120 VAC operation
•
25.0 A @ +3.3 V
–
– 5 A @ +5 V
– 12 A @ +12 V
27.89 A @ +42 V
–
200/240 VAC operation
•
25.0 A @ +3.3 V
–
5 A @ +5 V
–
12 A @ +12 V
–
65.98 A @ +42 V
–
A two-pin male Molex connector is located in the
lower right corner of the power supply front panel. The
connector provides 42 VDC at a maximum of 17 A.
This connector provides power to the
WS-6509-NEB-UPGRD kit fan assembly through a
power harness also provided in the kit. A hinged
protective flap secured by a captive screw covers the
connector when it is not in use.
20 ms minimum
12,046 BTU/hour (approx.)
Green—Source AC voltage is OK. (Input voltage
•
is 85 VAC or greater.)
Off—Source AC voltage falls below 70 VAC, is
•
not present, or the power supply is turned off.
Green—Power supply fan is operating properly.
•
Off—Power supply fan failure is detected.
•
Red—Problem with one or more of the DC-output
•
voltages of the power supply.
Off—DC-output voltages within acceptable
•
margins.
Green—42 VDC is present at the fan power
•
connector.
Off—42 VDC is not present at the fan power
•
connector.
15.8 lb (7.2 kg)
Power Supply Specifications
OL-5781-04