Cisco 6509 - Catalyst Chassis Switch Installation Manual page 91

Chapter 2 Preparing for Installation
Plan ahead. Your Catalyst 6500 series switches currently installed in an enclosed or partially
•
enclosed rack might meet ambient air temperature and air flow requirements now. However, if you
add more chassis to the rack or you add more modules to a chassis in the rack, the additional heat
generated might cause the ambient air temperature within the rack to exceed 40°C (104°F) and can
cause minor alarms.
If an individual fan within the assembly fails, the FAN STATUS LED turns red. Individual fans cannot
be replaced. To replace a fan assembly, see the
page 4-57.
Refer to your software configuration guide for information on environmental monitoring.
Table 2-2
Chassis
Catalyst 6503
Catalyst 6503-E
Catalyst 6504-E
Catalyst 6506
Catalyst 6506-E
Catalyst 6509
Catalyst 6509-E
Catalyst 6509-NEB
Catalyst 6509-NEB-A
Catalyst 6513
1. Optional high-speed fan tray is part of the WS-6509-NEB-UPGRD kit.
OL-5781-04
Catalyst 6500 Series Chassis Fan Tray Support
Supported Fan Trays
FAN-MOD-3
FAN-MOD-3HS (high speed)
WS-C6503-E-FAN
FAN-MOD-4HS (high speed)
WS-C6K-6SLOT-FAN
WS-C6K-6SLOT-FAN2 (high
speed)
WS-6506-E-FAN
WS-C6K-9SLOT-FAN
WS-C6K-9SLOT-FAN2 (high
speed)
WS-6509-E-FAN
WS-C6509-NEB-FAN
WS-6509-NEB-UPGRD
speed)
FAN-MOD-09
WS-C6K-13SLOT-FAN
WS-C6K-13SLT-FAN2 (high
speed)
"Removing and Installing the Fan Assembly" section on
Non-Supported Fan Trays
WS-C6503-E-FAN
FAN-MOD-3
FAN-MOD-3HS (high speed)
—
WS-6506-E-FAN
WS-C6K-6SLOT-FAN
WS-C6K-6SLOT-FAN2 (high
speed)
WS-6509-E-FAN
WS-C6K-9SLOT-FAN
WS-C6K-9SLOT-FAN2 (high
speed)
—
1
(high
—
—
Catalyst 6500 Series Switches Installation Guide
Site Requirements
2-11