Switches - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Installing the Rack-Mount Kit
Figure 3-2
M3 screw
Installing the L Brackets and Cable Guides on the Catalyst 6503 and the
Catalyst 6503-E Switches
The Catalyst 6503 and the Catalyst 6503-E switch chassis are normally shipped with the L brackets
Note
installed. If the chassis does not have the L brackets installed, follow the steps in this section to install
the L brackets on your Catalyst 6503 or Catalyst 6503-E switch chassis. You can also remove the
L brackets from the front of the chassis and reattach them to the rear of the chassis.
The L brackets attach to the Catalyst 6503 and the Catalyst 6503-E switch chassis using eight M3
Phillips countersunk-head screws (four M3 screws on each side). You attach the optional cable guides
by sandwiching them between the L brackets and switch chassis.
To install the L brackets on the front of the Catalyst 6503 and the Catalyst 6503-E switch chassis,
perform these steps:
Position one of the brackets against the chassis side, and align the screw holes. (See
Step 1
Secure the bracket to the chassis with four M3 screws.
Step 2
Repeat Steps 1 and 2 for the other bracket.
Step 3
Catalyst 6500 Series Switches Installation Guide
3-6
Attaching the Crossbar Bracket to the Shelf Brackets
Shelf bracket
Crossbar
bracket
Front of rack
Shelf bracket
M3 screw
Chapter 3 Installing the Switch
Figure 3-3.)
OL-5781-04