Power Supply Redundancy - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Appendix A Power Supply Specifications
Figure A-45 WS-CAC-4000W-INT=
Plug: IEC 60309
Figure A-46 WS-CAC-4000W-US=
Plug: NEMA L6-30

Power Supply Redundancy

Catalyst 6500 series switching modules have different power requirements. Depending upon the wattage
of the power supply, certain switch configurations might require more power than a single power supply
can provide. Although the power management feature allows you to supply power to all installed
modules with two power supplies, redundancy is not supported in this configuration. Redundant and
nonredundant power configurations are summarized in
supply configurations are summarized in
For proper load-sharing operation in a redundant power supply configuration, you must install two
Note
modules in the chassis. If you fail to install two modules, you might receive spurious OUTPUT FAIL
indications on the power supply.
OL-5781-04
Cordset rating: 32 A, 250 V
Length: 12 ft 0 in. (3.65 m)
Cordset rating: 30 A, 250 V
Length: 12 ft 0 in. (3.65 m)
Hardwired to
power
supply
Hardwired to
power
supply
Table
Table A-22.
Catalyst 6500 Series Switches Installation Guide
Power Supply Redundancy
A-21. The effects of changing the power
A-57