Cisco 6509 - Catalyst Chassis Switch Installation Manual page 304

Cleaning the Fiber Optic Connectors
The connection quality depends on two factors: the type of connector and the proper cleaning and
connection techniques. Dirty fiber connectors are a common source of light loss. Keep the connectors
clean at all times, and keep the dust covers installed when the connectors are not in use.
Before installing any type of cable or connector, use a lint-free alcohol pad from a cleaning kit to clean
the ferrule, the protective white tube around the fiber, and the end-face surface of the fiber.
As a general rule, whenever there is a significant, unexplained loss of light, clean the connectors.
Caution Use extreme care when removing or installing connectors so that you do not damage the connector
housing or scratch the end-face surface of the fiber. Always install protective covers on unused or
disconnected components to prevent contamination. Always clean fiber connectors before installing
them.
To clean the optical connectors, use a CLETOP cassette cleaner (type A for SC connectors or type B for
MT-RJ connectors) and follow the product directions. If a CLETOP cassette cleaner is not available,
follow these steps:
Use a lint-free tissue soaked in 99 percent pure isopropyl alcohol to gently wipe the faceplate. Wait five
Step 1
seconds for the surfaces to dry, and repeat.
Step 2 Remove any residual dust from the faceplate with clean, dry, oil-free compressed air.
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Use a magnifying glass or inspection microscope to inspect the ferrule at an angle. Do not look directly
Step 3
into the aperture. Repeat the process if any contamination is detected.
The connectors used inside the system have been cleaned by the manufacturer and connected to the
adapters in the proper manner. The operation of the system should be error free if the customer provides
clean connectors on the application side, follows the previous directions, and follows these guidelines:
Clean the connectors using either a CLETOP cassette cleaner (Type A for SC connectors and Type
•
B for MT-RJ connectors) or lens tissues before connecting to the adapters. Use pure alcohol to
remove contamination.
Do not clean the inside of the connector adapters.
•
Do not use force or quick movements when connecting the fiber optic connectors in the adapters.
•
Cover the connectors and adapters to keep the inside of the adapters or the surface of the connectors
•
from getting dirty when you are not using the connectors or while you are cleaning the chassis.
Catalyst 6500 Series Switches Installation Guide
B-32
Appendix B Transceivers, Module Connectors, and Cable Specifications
OL-5781-04