1300 W Power Supply Specifications - Cisco 6509 - Catalyst Chassis Switch Installation Manual

1300 W AC-Input and DC-Input Power Supplies

1300 W Power Supply Specifications

Table A-7
Table A-7
Specification
AC-input type
AC-input voltage
AC-input current
kVA rating
Branch circuit requirement (AC-input)
Catalyst 6500 Series Switches Installation Guide
A-14
lists the specifications for the 1300 W AC-input and DC-input power supplies.
1300 W AC-Input and DC-Input Power Supplies Specifications
Appendix A
Description
Autoranging input with power factor correction (PFC).
Power factor correction is a standard feature on
Note
all Catalyst 6500 series AC-input power
supplies. PFC reduces the reactive component
in the source AC current allowing higher power
factors (typically 99 percent or better) and
lower harmonic current components.
100 to 240 VAC (±10% for full range)
16 A @ 100 VAC
•
8 A @ 240 VAC
•
1625 kVA
Each chassis power supply should have its own
dedicated, fused-branch circuit:
• For North America—15 A or 20 A
• For International—Circuits sized to local and
national codes
• All Catalyst 6500 series AC-input power supplies
require single-phase source AC.
• All AC power supply inputs are fully isolated.
Source AC can be out of phase between
–
multiple power supplies in the same chassis,
which means that PS1 can be operating from
phase A and PS2 can be operating from
phase B.
Source AC can be out of phase between AC
–
inputs on power supplies that are equipped
with multiple AC inputs, which means that
power cord 1 can be plugged into phase A and
power cord 2 can be plugged into phase B.
Power Supply Specifications
OL-5781-04