Catalyst 6509-E Switch - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Catalyst 6509-E Switch

Catalyst 6509-E Switch
The Catalyst 6509-E switch is a 9-slot horizontal chassis.
Catalyst 6509-E switch chassis.
Figure 1-10
Table 1-13 Catalyst 6509-E Switch Features
Feature
Chassis
Supervisor Engines
Modules
Backplane Bandwidth
Clock and VTT Modules
Catalyst 6500 Series Switches Installation Guide
1-34
Table 1-14
shows the Catalyst 6509-E switch.
Description
Nine horizontal slots. Slots are numbered from (1) top to (9) bottom.
•
Supports Supervisor Engine 1, Supervisor Engine 2, Supervisor
•
Engine 32, and Supervisor Engine 720.
Supervisor Engine 1 and Supervisor Engine 2 are installed in slot 1
–
and slot 2.
Supervisor Engine 32 and Supervisor Engine 720 are installed in
–
slot 5 and slot 6.
Supervisor Engine 720 has built-in switching fabric. Switch Fabric
–
Modules are not supported by Supervisor Engine 720 and cannot be
installed in the same chassis.
The uplink ports are fully functional on all redundant supervisor engine
•
models when they are in standby mode.
Redundant supervisor engines must be configured identically.
Note
Supports up to eight Catalyst 6500 series modules.
•
WS-C6500-SFM and WS-X6500-SFM2 Switch Fabric Modules must be
•
installed in slot 5 or slot 6.
Some Catalyst 6500 series modules may:
•
Not be supported
–
Require that you install a Supervisor Engine 720
–
– Have chassis slot restrictions
– Require a specific software release level
Check your software release notes for specific information.
32 GBps shared bus.
•
256 GBps switch fabric.
•
720 GBps switch fabric.
•
• Two replaceable clock modules (CLK-7600=) provide clocking signals
to the EOBC channel and the switching bus.
• Three replaceable voltage termination (VTT) modules
(WS-C6K-VTT-E=) provide reference voltage for bus signals.
Table 1-13
lists the specifications of the Catalyst 6509-E switch chassis.
Chapter 1 Product Overview
lists the features of the
OL-5781-04