Attaching The Optional Cable Guide - Cisco Catalyst 3550 Hardware Installation Manual

Installing the Switch

Attaching the Optional Cable Guide

Figure 2-6 Attaching the Cable Guide
SYS TEM
RPS
MO DE
STA TUS
UTI L
DUP LX
SPE ED
1
Cable guide screw
Table or Shelf Mounting
Step 1
Step 2
Catalyst 3550 Multilayer Switch Hardware Installation Guide
2-14
We recommend attaching the cable guide to prevent the cables from obscuring the
front panel of the switch and the other devices installed in the rack. If the switch
is in a 19-inch or 24-inch rack, use the supplied black screw, as shown in
Figure 2-6, to attach the cable guide to the left or right bracket.
2
3
4
5
6
7
Follow these steps to install the switch on a table or shelf:
Locate the adhesive strip with the rubber feet in the mounting-kit envelope.
Attach the four rubber feet to the recessed areas on the bottom of the unit.
Place the switch on the table or shelf near an AC power source.
After the switch is mounted on the table or shelf, see
and Running POST" section on page 2-17
Chapter 2
C at al ys t
35 50
8
9
10
1
2
to complete the installation.
Installing and Starting the Switch
"Powering On the Switch
78-11358-01