Attaching The Cable Guide - Cisco Catalyst 3750 Hardware Installation Manual

Chapter 3 Switch Installation

Attaching the Cable Guide

78-15136-03
After the switch is mounted in the rack, you might need to perform these tasks to
complete the installation, run the setup program, and access the switch:
(Optional) Connect the switches in the stacks. See the
•
StackWise Cable to StackWise Ports" section on page
Connect to the console port, and start the emulation software. See the
•
"Connecting to the Console Port" section on page C-7
Terminal Emulation Software" section on page
Power on the switch. See the
•
page C-9. If the switches are stacked, see the
section on page 3-15.
Run the setup program. See the
•
page C-11.
Connect to the front-panel ports. See the
•
10/100/1000 Ports" section on page
Module" section on page
section on page 3-59
To use the CLI, enter commands at the Switch> prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, refer to the switch software configuration guide or the
switch command reference.
We recommend attaching the cable guide to prevent the cables from obscuring the
front panel of the switch and the other devices installed in the rack. Use the
supplied black screw, as shown in
guide to the left or right bracket.
"Connecting to a Power Source" section on
"Completing the Setup Program" section on
"Connecting to the 10/100 and
3-51, the
3-55, and the "Connecting to a XENPAK Module"
to complete the installation.
Figure 3-28 and
Catalyst 3750 Switch Hardware Installation Guide
Installing the Switch
"Connecting
3-38.
and the "Starting the
C-9.
"Powering Considerations"
"Connecting to an SFP
Figure 3-29 to attach the cable
3-31