Monitoring And Maintaining Mpls And Eompls - Cisco 3845 - Security Bundle Router Software Manual

Monitoring and Maintaining MPLS and EoMPLS

Command
Step 19
copy running-config startup-config
Step 20
show ip sla monitor mpls-lsp-monitor
collection-statistics [group-id]
show ip sla mpls-lsp-monitor lpd
operational-state
Monitoring and Maintaining MPLS and EoMPLS
To clear MPLS counters or display MPLS and EoMPLS information, use the privileged EXEC
commands in
Table 34-2 Commands for Displaying MPLS and EoMPLS Information
Command
clear mpls counters
clear mpls traffic-eng autotunnel primary
show interface tunnel tunnel-number
show ip explicit paths
show ip rsvp fast reroute [detail]
show ip rsvp host
show isis database verbose
show isis mpls traffic-eng
show mpls forwarding-table
show mpls interfaces
show mpls ip binding
show mpls l2transport vc [detail] [summary]
show mpls l2transport vc [vc-id] [vc-id-min -
vc-id-max]
show mpls label range
show mpls ldp backoff
show mpls ldp bindings
show mpls ldp discovery
Cisco ME 3800X and 3600X Switch Software Configuration Guide
34-60
Table 34-2.
Purpose
Clear MPLS forwarding counters.
Remove all primary auto tunnels and recreate them.
Display information about the specified tunnel interface.
Display the configured IP explicit paths.
Display specific information for RSVP categories, including fast reroute.
Display RSVP terminal point information for receivers or senders
Display information about the IS-IS database.
Display information about IS-IS MPLS traffic engineering.
Display the contents of the MPLS label forwarding information base
(LFIB).
Display information about interfaces that have been configured for label
switching.
Display specified information about label bindings learned by LDP.
Display detailed or summary information about the EoMPLS virtual
connections that have been enabled to route Layer 2 packets on a
provider-edge device.
Display information about the specified virtual connection or range of
virtual-connections. The range is from 1 to 4294967295.
Display the range of local labels available for use on packet interfaces.
Display information about the configured session setup backoff
parameters and any potential LDP peers with which session setup
attempts are being throttled.
Display the contents of the label information base (LIB).
Display the status of the LDP discovery process.
Chapter 34 Configuring MPLS, MPLS VPN, MPLS OAM, and EoMPLS
Purpose
(Optional) Save your entries in the configuration file.
(Optional) Displays the statistics for IP SLAs operations
belonging to an LSP discovery group of an LSP Health
Monitor operation.
Optional) Displays the operational status of the LSP
discovery groups belonging to an LSP Health Monitor
operation.
Note These commands are applicable only if the LSP
discovery option is enabled.
OL-23400-01