Configuring The Ip Slas Responder - Cisco 3845 - Security Bundle Router Software Manual

Chapter 31 Configuring Cisco IOS IP SLAs Operations
Type of Operation to Perform: 802.1agEcho
Type of Operation to Perform: 802.1agJitter
Type of Operation to Perform: dhcp
Type of Operation to Perform: dns
Type of Operation to Perform: echo
Type of Operation to Perform: ftp
Type of Operation to Perform: http
Type of Operation to Perform: jitter
Type of Operation to Perform: pathEcho
Type of Operation to Perform: pathJitter
Type of Operation to Perform: tcpConnect
Type of Operation to Perform: udpEcho
IP SLAs low memory water mark: 21741224

Configuring the IP SLAs Responder

The IP SLAs responder is available only on Cisco IOS software-based devices, including some Layer 2
switches that do not support full IP SLAs functionality, such as the Catalyst 2960 or the Cisco ME 2400
switch or a Cisco ME 3400 switch running the metro base image. Beginning in privileged EXEC mode,
follow these steps to configure the IP SLAs responder on the target device (the operational target):
Command
Step 1 configure terminal
Step 2 ip sla responder {tcp-connect |
udp-echo} ipaddress ip-address port
port-number
Step 3 end
Step 4 show ip sla responder
Step 5 copy running-config startup-config
To disable the IP SLAs responder, enter the no ip sla responder global configuration command. This
example shows how to configure the device as a responder for the UDP jitter IP SLAs operation in the
next procedure:
Switch(config)# ip sla responder udp-echo 172.29.139.134 5000
OL-23400-01
Supported Operation Types
Purpose
Enter global configuration mode.
Configure the switch as an IP SLAs responder.
The keywords have these meanings:
• tcp-connect—Enable the responder for TCP connect operations.
• udp-echo—Enable the responder for User Datagram Protocol (UDP)
echo or jitter operations.
ipaddress ip-address—Enter the destination IP address.
•
• port port-number—Enter the destination port number.
Note
Return to privileged EXEC mode.
Verify the IP SLAs responder configuration on the device.
(Optional) Save your entries in the configuration file.
The IP address and port number must match those configured on
the source device for the IP SLAs operation.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring IP SLAs Operations
31-7