Displaying Igmp Filtering And Throttling Configuration - Cisco 3845 - Security Bundle Router Software Manual

Displaying IGMP Filtering and Throttling Configuration

Command
Step 4
end
Step 5
show running-config interface
interface-id
Step 6
copy running-config startup-config
To return to the default action of dropping the report, use the no ip igmp max-groups action interface
configuration command.
This example shows how to configure a port to remove a randomly selected multicast entry in the
forwarding table and to add an IGMP group to the forwarding table when the maximum number of
entries is in the table.
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip igmp max-groups action replace
Switch(config-if)# end
Displaying IGMP Filtering and Throttling Configuration
You can display IGMP profile characteristics, and you can display the IGMP profile and maximum group
configuration for all interfaces on the switch or for a specified interface. You can also display the IGMP
throttling configuration for all interfaces on the switch or for a specified interface.
Use the privileged EXEC commands in
configuration:
Table 18-6 Commands for Displaying IGMP Filtering and Throttling Configuration
Command
show ip igmp profile [profile
number]
show running-config [interface
interface-id]
Cisco ME 3800X and 3600X Switch Software Configuration Guide
18-18
Purpose
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
Purpose
Displays the specified IGMP profile or all the IGMP profiles defined on the switch.
Displays the configuration of the specified interface or the configuration of all interfaces
on the switch, including (if configured) the maximum number of IGMP groups to which
an interface can belong and the IGMP profile applied to the interface.
Table 18-6 to display IGMP filtering and throttling
Chapter 18 Configuring IGMP Snooping
OL-23400-01