Configuring Ethernet Interfaces; Default Ethernet Interface Configuration - Cisco 3845 - Security Bundle Router Software Manual

Chapter 9 Configuring Interfaces
Table 1
Command
arp [ip_address]
mgmt_clr
mgmt_init
mgmt_show
ping host_ip_address
boot tftp:/file-url ...
copy tftp:/source-file-url
filesystem:/destination-file-
url
1. ARP = Address Resolution Protocol.

Configuring Ethernet Interfaces

•
•
•
•
•

Default Ethernet Interface Configuration

Table 9-2
listed in the table, see
see
To configure Layer 2 parameters, if the interface is in Layer 3 mode, you must enter the switchport
Note
interface configuration command without any parameters to put the interface into Layer 2 mode. This
shuts down the interface and then re-enables it, which might generate messages on the device to which
the interface is connected. When you put an interface that is in Layer 3 mode into Layer 2 mode, the
previous configuration information related to the affected interface might be lost, and the interface is
returned to its default configuration.
OL-23400-01
Boot Loader Commands
Default Ethernet Interface Configuration, page 9-13
Configuring Interface Speed and Duplex Mode, page 9-14
Configuring IEEE 802.3x Flow Control, page 9-17
Configuring Auto-MDIX on an Interface, page 9-18
Adding a Description for an Interface, page 9-19
shows the Ethernet interface default configuration. For more details on the VLAN parameters
Chapter 10, "Configuring VLANs."
Chapter 19, "Configuring Traffic Control."
Description
Displays the currently cached ARP
without the ip_address parameter.
Enables ARP to associate a MAC address with the specified IP address
when this command is entered with the ip_address parameter.
Clears the statistics for the Ethernet management port.
Starts the Ethernet management port.
Displays the statistics for the Ethernet management port.
Sends ICMP ECHO_REQUEST packets to the specified network host.
Loads and boots an executable image from the TFTP server and enters
the command-line interface.
For more details, see the command reference for this release.
Copies a Cisco IOS image from the TFTP server to the specified
location.
For more details, see the command reference for this release.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring Ethernet Interfaces
1
table when this command is entered
For details on controlling traffic to the port,
9-13