Lldp And Ethernet Flow Points (Efps); Monitoring And Maintaining Lldp And Lldp-Med - Cisco 3845 - Security Bundle Router Software Manual

Chapter 21 Configuring LLDP and LLDP-MED
Command
Step 3
lldp med-tlv-select tlv
Step 4
end
Step 5
copy running-config startup-config
This example shows how to enable a TLV on an interface when it has been disabled.
Switch# configure terminal
Switch(config)# interface GigabitEthernet1/0/1
Switch(config-if)# lldp med-tlv-select inventory-management
Switch(config-if)# end

LLDP and Ethernet Flow Points (EFPs)

For LLDP to peer with a neighbor on a port that has an Ethernet Virtual Connection (EVC) EFP service
instance configured, you need to enter the l2 protocol peer lldp service-instance configuration
command on the service instance. See the
for more information on EFPs.
This example shows how to configure Layer 2 protocol peer on a service instance:
Switch (config)# interface gigabitethernet0/1
Switch (config-if)# switchport mode trunk
Switch (config-if)# switchport trunk allowed vlan none
Switch (config-if)# service instance 1 Ethernet
Switch (config-if-srv)# encapsulation untagged
Switch (config-if-srv)# l2protocol peer lldp
Switch (config-if-srv)# bridge-domain 10
Switch (config-if-srv)# end

Monitoring and Maintaining LLDP and LLDP-MED

To monitor and maintain LLDP and LLDP-MED on your device, perform one or more of these tasks,
beginning in privileged EXEC mode.
Command
clear lldp counters
clear lldp table
show lldp
show lldp entry entry-name
show lldp interface [interface-id]
OL-23400-01
Purpose
Specify the TLV to enable.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
"Configuring Ethernet Virtual Connections (EVCs)"
Description
Reset the traffic counters to zero.
Delete the LLDP table of information about neighbors.
Display global information, such as frequency of transmissions, the holdtime for
packets being sent, and the delay time for LLDP to initialize on an interface.
Display information about a specific neighbor.
You can enter an asterisk (*) to display all neighbors, or you can enter the name
of the neighbor about which you want information.
Display information about interfaces where LLDP is enabled.
You can limit the display to the interface about which you want information.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Monitoring and Maintaining LLDP and LLDP-MED
chapter
21-7