C H A P T E R 2 Using The Command-Line Interface - Cisco 3845 - Security Bundle Router Software Manual

Understanding Command Modes
Table 2-1 Command Mode Summary
Mode Access Method
User EXEC Begin a session with
your switch.
Privileged EXEC While in user EXEC
mode, enter the
enable command.
Global configuration While in privileged
EXEC mode, enter
the configure
command.
VLAN configuration While in global
configuration mode,
enter the
vlan vlan-id
command.
Interface While in global
configuration configuration mode,
enter the interface
command (with a
specific interface).
Line configuration While in global
configuration mode,
specify a line with
the line vty or line
console command.
For more detailed information on the command modes, see the command reference guide for this release.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
2-2
Prompt Exit Method
Switch>
Switch#
Switch(config)#
Switch(config-vlan)#
Switch(config-if)#
Switch(config-line)#
Chapter 2 Using the Command-Line Interface
About This Mode
Enter logout or Use this mode to
quit.
•
•
•
Enter disable to Use this mode to verify
exit. commands that you have
entered. Use a password to
protect access to this mode.
To exit to privileged Use this mode to configure
EXEC mode, enter parameters that apply to the
exit or end, or press entire switch.
Ctrl-Z.
To exit to global Use this mode to configure
configuration mode, VLAN parameters.
enter the exit
command.
To return to
privileged EXEC
mode, press Ctrl-Z
or enter end.
To exit to global Use this mode to configure
configuration mode, parameters for the Ethernet
enter exit. ports.
To return to For information about defining
privileged EXEC interfaces, see the
mode, press Ctrl-Z Interface Configuration Mode"
or enter end. section on page
To configure multiple
interfaces with the same
parameters, see the
"Configuring a Range of
Interfaces" section on
page
To exit to global Use this mode to configure
configuration mode, parameters for the terminal
enter exit. line.
To return to
privileged EXEC
mode, press Ctrl-Z
or enter end.
Change terminal settings.
Perform basic tests.
Display system
information.
"Using
9-6.
9-7.
OL-23400-01