Cisco 3845 - Security Bundle Router Software Manual page 206

Monitoring and Maintaining the Interfaces
Table 9-4 Show Commands for Interfaces
Command
show interfaces [interface-id]
show interfaces interface-id status [err-disabled]
show interfaces [interface-id] switchport
show interfaces [interface-id] description
show ip interface [interface-id]
show interface [interface-id] stats
show interfaces [interface-id] transceiver [detail |
dom-supported-list | module number | properties |
threshold-table]
show port-type [eni | nni | uni]
show running-config interface [interface-id]
show version
show controllers ethernet-controller interface-id
phy
Cisco ME 3800X and 3600X Switch Software Configuration Guide
9-22
Purpose
Display the status and configuration of all interfaces or a specific
interface.
Display interface status or a list of interfaces in an error-disabled state.
Display administrative and operational status of switching mode. You
can use this command to find out if a port is in routing or in switching
mode.
Display the description configured on an interface or all interfaces and
the interface status.
Display the usability status of all interfaces configured for IP routing
or the specified interface.
Display the input and output packets by the switching path for the
interface.
Display these physical and operational status about an SFP module:
• interface-id–(Optional) Display configuration and status for a
specified physical interface.
detail–(Optional) Display calibration properties, including high
•
and low numbers and any alarm information for any Digital
Optical Monitoring (DoM)-capable transceiver if one is installed
in the switch.
dom-supported-list–(Optional) List all supported DoM
•
transceivers.
module number–(Optional) Limit display to interfaces on module
•
on the switch. The range is 1 to 9. This option is not available if
you entered a specific interface ID.
properties–(Optional) Display speed, duplex, and inline power
•
settings on an interface
threshold-table–(Optional) Display alarm and warning threshold
•
table
Display interface type information for the Cisco ME switch. The only
valid type is nni. Other keywords show no output.
Display the running configuration in RAM for the interface.
Display the hardware configuration, software version, the names and
sources of configuration files, and the boot images.
Display the operational state of the auto-MDIX feature on the
interface. - Doesn't seem to show this
Chapter 9 Configuring Interfaces
OL-23400-01