Displaying Igmp Filtering And Throttling Configuration - Cisco Catalyst 2975 Software Configuration Manual

Chapter 22 Configuring IGMP Snooping and MVR
Command
Step 4
end
Step 5
show running-config interface
interface-id
Step 6 copy running-config startup-config
To return to the default action of dropping the report, use the no ip igmp max-groups action interface
configuration command.

Displaying IGMP Filtering and Throttling Configuration

You can display IGMP profile characteristics, and you can display the IGMP profile and maximum group
configuration for all interfaces on the switch or for a specified interface. You can also display the IGMP
throttling configuration for all interfaces on the switch or for a specified interface.
Use the privileged EXEC commands in
configuration:
Table 22-8 Commands for Displaying IGMP Filtering and Throttling Configuration
Command
show ip igmp profile [profile
number]
show running-config [interface
interface-id]
OL-19720-02
Purpose
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
Table 22-8
Purpose
Displays the specified IGMP profile or all the IGMP profiles defined on the switch.
Displays the configuration of the specified interface or the configuration of all interfaces
on the switch, including (if configured) the maximum number of IGMP groups to which
an interface can belong and the IGMP profile applied to the interface.
Displaying IGMP Filtering and Throttling Configuration
to display IGMP filtering and throttling
Catalyst 2975 Switch Software Configuration Guide
22-29