Remove I/O Tray - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 3

Remove I/O Tray

23. Disconnect three
peripheral bay ribbon cables.
Figure 3-9. Remove Embedded I/O Cover, Disconnect Peripheral Bay Cables,
22. Remove the embedded I/O cover from the I/O tray. (See Figure 3-9.)
Place the I/O cover on the table with items that will not be reused in the
NetServer LXr 8500.
23. Disconnect the three peripheral bay ribbon cables from the I/O baseboard.
To help you reconnect these cables later, you should label each cable as
you disconnect it.
24. Remove all of the boards in the I/O tray, and place them on anti-static
mats.
All of the boards from the LXr 8000 I/O tray will be reused in the
LXr 8500.
28
22. Remove embedded I/O cover.
24. Remove all boards from
the I/O tray.
and Remove I/O Boards
Disassembling the LXr 8000
Note:
SCSI extender cable
(not shown)
connects here.
It is not necessary
to disconnect this
cable.