HP D7171A - NetServer - LPr Upgrade Manual page 42

Chapter 4
2. Place the processor tray for the LXr 8000 on a table next to the LXr 8500.
NOTE Placing the two processor trays next to each other will reduce
the chance of damaging a processor due to static electricity
when you move the processor from the old tray to the new tray.
3. Open and remove the processor cage covers on both the LXr 8000 and the
LXr 8500 processor cages. Loosen the captive screws that hold down the
cover of each processor cage. Swing open each cover until it points straight
up, then lift it out.
4. Remove just one processor module from the LXr 8000 and insert it into the
LXr 8500 as follows (see Figure 4-2):
a. Open the retaining latches of one processor module, lift to remove the
module, then turn it 180
b. Make sure that the retaining latches on top of the processor module are
open (pointing straight up). Slide the processor module into the one
empty slot (slot 1) in the processor cage, and rotate the retaining latches
into the closed position.
c. Do not install additional processor modules or remove any terminators
at this time. You will finish installing processors after your preliminary
hardware verification, discussed in Chapter 6.
d. Check that all terminators are firmly place by pressing down on each
one and verifying that the retaining latches are closed.
36
Preparing to Assemble the LXr 8500
o
.