HP D7171A - NetServer - LPr Upgrade Manual page 50

Chapter 5
3a. Orient the center support
so the plastic PCI board
guides face the back
of the NetServer.
3. Locate the LXr 8500 center support and install it as follows (see
Figure 5-3):
a. Orient the center support so the plastic PCI board guides face the back
of the NetServer where you will reinstall the I/O tray.
b. Place the center support on top of the midplane board. Tabs on the
midplane board protrude through slots in the center support.
c. Fasten the three screws.
44
3b. Place the center support
on top of the midplane.
3c. Fasten three screws.
Figure 5-3. Install Center Support
Assembling the LXr 8500