Power Down The Server Blade; Remove The Server Blade - HP ProLiant BL45p Maintenance And Service Manual

Power down the server blade

Power down the server blade using either of the following methods:
•
Press the Power On/Standby button on the server blade front panel.
Be sure that the server blade is in standby mode by observing that the system power LED is amber.
This process may take 30 seconds, during which time some internal circuitry remains active.
•
Use the virtual power button feature in iLO 2.
After initiating a manual or virtual power down command, be sure that the server blade goes into
standby mode by observing that the system power LED is amber.
IMPORTANT:
provided. To remove all power from the server blade, remove the server blade from the server
blade enclosure.
IMPORTANT:
enclosure and server blade enclosure management modules. For the most recent firmware,
refer to the HP website (http://www.hp.com/go/support).

Remove the server blade

Identify the proper server blade.
1.
Back up all server blade data.
2.
Power down the server blade (on page 28).
3.
Remove the server blade from the server blade enclosure.
4.
Place the server blade on a flat, level work surface.
5.
WARNING:
internal system components to cool before touching them.
All manuals and user guides at all-guides.com
When the server blade is in standby mode, auxiliary power is still being
Remote power procedures require the most recent firmware for the power
To reduce the risk of personal injury from hot surfaces, allow the drives and the
Removal and replacement procedures 28