Apply Gaskets To Chassis - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 3

Apply Gaskets to Chassis

31. Remove 4 screws and
slide out peripheral bay.
Figure 3-14. Remove Peripheral Bay and Apply Foam Gaskets
31. Remove the four screws that secure the peripheral bay to the chassis and
slide out the peripheral bay. (See Figure 3-14.)
NOTE
Sheet metal surfaces must be free of oil, grease, and other
foreign material to ensure good adhesion of gaskets. Clean the
chassis with alcohol or other fluid as necessary.
32. Locate the two short folded foam gaskets that are approximately 1 inch in
length. Remove the adhesive strip covering and apply the gaskets to the
bottom of the chassis as shown in Figure 3-14.
33. Reinsert the peripheral bay and secure all four screws.
32. Remove adhesive strip covering from
2 short folded foam gaskets and apply
to bottom corners of chassis.
33. Reinsert the peripheral bay
and secure all 4 screws.
Disassembling the LXr 8000
33