Install The I/O Baseboard And Tray - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 5

Install the I/O Baseboard and Tray

6a. Lower the I/O tray
into place.
6c. Fasten all three screws.
Figure 5-6. Install I/O Baseboard and Tray
6. Install the LXr 8500 I/O tray as follows (see Figure 5-6):
a. Set the I/O tray into place.
b. Press the latches back to engage the connectors.
c. Fasten all three screws.
WARNING
It is important that you install the I/O tray before the
processor tray, and that you screw in all three of the I/O tray
screws at this time. If this order of assembly is not followed,
you might find problems with the interconnects and with the
alignment of screws.
Assembling the LXr 8500
6b. Press the latches back.
47