HP D7171A - NetServer - LPr Upgrade Manual page 58

Chapter 5
Figure 5-11. Open the PCI Hold-down Latch in Slot 2
11. Locate Slot 2 on the I/O baseboard (see Figure 5-8) and open the PCI
hold-down latch. (See Figure 5-11.)
12. Install the Remote Control
card in Slot 2.
Figure 5-12. Install the Remote Control Card
12. Install the remote control card (RCC) in Slot 2. (See Figure 5-12.)
13. Connect the RCC cable to the connector labeled J1F1 on the I/O
baseboard.
52
Assembling the LXr 8500
11. Press the center of the
PCI hold-down latch in
Slot 2. Then swing
it back out of the way.
13. The Remote Control
card cable passes over the
top of the slot dividers and
connects to J1F1 on the I/O
baseboard.