Raidcom Modify Port; Syntax; Options And Parameters - HP StorageWorks P9000 Reference Manual

FPMA
This displays FP MAC address setting to this port.
VPS
This displays VP status.
DWN: the Link status is in Link Down.
LOT: the Link status is in Link Up and Log-Out.
LIN: the Link status is in Link Up and Log-In.
VP_I
This displays VP Index, but this value is always zero currently.
FCF_I
This displays FCF Index, but this value is always zero currently.

raidcom modify port

Sets the attribute value of the specified port.
The specified port must be "TYPE=FIBRE and ATTR=TAR", if not it will be rejected with EX_ENOOBJ.
When transmitting a fiber channel frame over Ethernet, this specifies the Port speed: 10G, Port
topology: f_port.

Syntax

raidcom modify port -port <port>{[-port_speed <value>] [-loop_id <value>]
[-topology <topology>] [-security_switch < y|n >] | -port_attribute <port attribute>}

Options and parameters

Option
-port <port>
[ -port_speed <value>
]
[-loop_id < alpa
value> ]
[ -topology <
topology> ]
176 Configuration setting commands
Description
Specifies a port number.
For example:
CL1-A
Specifies a HOST speed (0, 1, 2, 4, 8).
The contents that can be specified:
0: AUTO
1: 1G
2: 2G
4: 4G
8: 8G
If this specification is omitted, 0 is used.
Specifies a Loop ID (0x01-0xEF) of the port.
0xEF is used if the specification is omitted.
Specifies a topology of the port.
The contents that can be specified:
fl-port : fabric on and fcal
f-port : fabric on and PtoP
nl-port : fabric off and fcal
n-port : fabric off and PtoP
n-port is used if the specification is omitted.