HP StorageWorks P9000 Reference Manual page 78

Option
-vt [type]
-vs <bsize>
[slba] [elba]
78 Replication commands
Description
Specifies the following data type that assumes the target volumes as Oracle database. If [type] is
not specified, then this option will disable all of the checking.
redo8: The target volumes sets the parameter for validation checking as Oracle redo log files
(including archive logs) prior Oracle9I. This option sets <bsize> to 1(512bytes) or 2(1024bytes).
data8: The target volumes sets the parameter for validation checking as Oracle data files (including
control files) prior Oracle9I.
redo9: The target volumes sets the parameter for validation checking as Oracle redo log files
(including archive logs) for Oracle9IR2 or later. This option sets <bsize> to 1 (512 bytes) or 2
(1024 bytes).
data9: The target volumes sets the parameter for validation checking as Oracle data files (including
control files) for Oracle9IR2 later. For Oracle for Tru64 or Windows, set the parameter in the
init.ora file to "_HARD_PROTECTION = TRUE ". If not so, a parameter for validation must be
changed by using the following "-vmf we" option: raidvchkset -vt data9 -vmf we.
rd10g: The target volumes sets the parameter for validation checking as Oracle ALL files ( including
redo and data and RMAN backup piece) for Oracle10gR2 or later. This option sets <bsize> to
1(512bytes) or 2(1024bytes). This option sets to the low 5 bits DBA for checking regarding
CHK-F2.
Specifies the data block size of Oracle I/O and a region on a target volume for validation checking.
<bsize> is used when specifying the data block size of Oracle I/O, in units of 512 bytes. <bsize>
is able to specify between 1 (512 bytes) and 64 (32 KB) (effective size for Oracle is also 1-64).
[slba] [elba] is used when specifying a region defined between Start_LBA (0 based) and End_LBA
on a target volume for checking, in units of 512 bytes.
[slba] [elba] can be specified in hexadecimal (by addition of "0x ") or decimal notation. If this
option is not specified, then a region for a target volume is set as all blocks (slba=0,elba=0).