Returned Values - HP StorageWorks P9000 Reference Manual

Option
-fq
Restriction

Returned values

The pairsyncwait command sets the following returned values during exit, allowing you to check
the execution results.
Condition
When the -nowait option is
specified
When the -nowait option is
not specified
104 Replication commands
Description
Displays the number of remaining Q-Markers within the CT group by adding "QM-Cnt" to the last
column. "QM-Cnt" is shown as follows:
When specifying "-nowait -fq":
"QM-Cnt" is shown as the number of remaining Q-Marker at this time within CT group.
When specifying "-nowait -m <marker> -fq":
"QM-Cnt" is shown as the number of remaining Q-Marker from the specified <marker> within
CT group.
When specifying "TIMEOUT" without "-nowait":
"QM-Cnt" is shown as the number of remaining Q-Marker at this timeout within CT group.
"QM-Cnt" is shown as "-", if the status for Q-Marker is invalid (i.e., status is "BROKEN" or
"CHANGED").
Example:
# pairsyncwait -g oradb -nowait -fq
UnitID CTGID Q-Marker Status Q-Num QM-Cnt
0 3 01003408ef NOWAIT 2 120
# pairsyncwait -g oradb -nowait -m 01003408e0 -fq
UnitID CTGID Q-Marker Status Q-Num QM-Cnt
0 3 01003408e0 NOWAIT 2 105
# pairsyncwait -g oradb -t 50 -fq
UnitID CTGID Q-Marker Status Q-Num QM-Cnt
0 3 01003408ef TIMEOUT 2 5
Specified <group> volume must be PVol with status PAIR. Other cases reply with error (EX_INVVOL).
It is possible to issue pairsysncwait from S-VOL side with -m <marker>.
Returned value
Normal termination: 0. The status is NOWAIT.
Abnormal termination: Other than 0 to 127, see the execution logs for error details.
Normal termination:
0: The status is DONE (completion of synchronization).
1: The status is TIMEOUT (timeout).
2: The status is BROKEN (Q-marker synchronized process is rejected).
3: The status is CHANGED (Q-marker is invalid due to resynchronize).
Abnormal termination: Other than 0 to 127, see the execution logs for error details.