HP StorageWorks P9000 Reference Manual page 149

It shows the number of Q-markers remaining in the P-VOL journal volume.
D-SZ(BLK)
It shows the capacity of the data block size of the journal volume in units of 512 bytes.
Seq#
Sequential number.
Num
It shows the number of LDEVs configuring the journal volume.
LDEV #
LDEV number.
DOW
This displays "Data Overflow Watch" timer (in unit of Sec.) setting per the Journal.
PBW
This displays "Path Blockade Watch" (in unit of Sec.) timer setting per the Journal. If the setting is
more than 3600 seconds, it displays 6000 seconds.
APW
It shows "Active Path Watch" (in unit of Sec.) timer setting to detect any link failures.
TYPE
This displays a type for "Open" or "M/F" system.
TTYPE
This displays the timer type for M/F.
- system: using System timer.
- local: using Local timer.
MODE
This displays the status of the journal.
- HDD: Store the journal data to the journal volume (cache mode disabled).
- CACHE: Store the journal data to the cache (cache mode enabled).
IF
This displays the inflow control for journal.
E: Enable, D: Disable
DOW(S)
This displays "Data Overflow Watch" timer (in unit of Sec.) setting per the Journal.
PBW(M)
This displays "Path Blockade Watch" (in unit of Min.) timer setting per the Journal. If the setting is
more than 60 minutes, it displays 100 minutes.
CR
This displays the copy rate as "Low/Medium/High".
CS(bps)
This displays the copy speed as "10/100/256".
DM
This displays the copy mode as "Y/N" under failure of the delta resync.
- Y: copying ALL data.
- N: No copying.
raidcom get journal 149