Tools Required; Rack Configuration Tools - HP D5970A - NetServer - LCII Guía Del Usuario

Chapter 8
NOTE If the HP Netserver is completely configured by the vendor
before delivery to the customer, then mounting the HP
Netserver in the rack may be the final step in the installation
procedure.
CAUTION
If other rack components are to be mounted in the rack below
the HP Netserver, install those components before starting to
mount the Netserver.

Tools Required

This rack mounting kit is provided as a tool-less assembly, but does need a nut
drive or wrench to release the spring mechanism after shipping.
Nut driver (10-mm) or wrench (release spring mechanism after shipping)
Masking tape or marking pen

Rack Configuration Tools

The HP rack configuration tools, including white papers, are available on the
worldwide web at HP's web site.
Enter the following URL in your browser:
http://www.hp.com/netserver
At the Web site, search for "configuration tools" and "high density rack
solutions", specifically Rack Assistant, Rack Configuration, Order Assistant, and
HP Netserver High Density Rack Solutions Overview (LP 1000r and LP 2000r).
You can read about the tools or download copies for installation. These tools can
be used to plan a rack configuration for the components in your system.
The white papers, specifically HP Netserver High Density Rack Solutions
Overview (LP 1000r and LP 2000r), provide rack information for HP Netservers
in the high density racks and additional information for rack systems not listed in
this manual. You will need this information to complete a rack system installation.
Rack Mounting the HP Netserver (4-Post)
73