Cd-Rom Drive Does Not Work; Scsi Device Does Not Work; Replacing A Battery - HP D5970A - NetServer - LCII Guía Del Usuario

Chapter 12

CD-ROM Drive Does Not Work

1. Verify a CD is inserted in the drive.
2. Verify the power and data cables are correctly connected to the device.
3. Verify the CD-ROM is configured correctly in the menu located under the
Security menu in the Setup Utility.
4. If you intend to boot from the CD, ensure the option is enabled in the Setup
Utility.
5. For further information, refer to your CD-ROM documentation.

SCSI Device Does Not Work

If error messages display on the monitor indicating a failure of a SCSI hard disk
or tape backup device, perform these checks:
1. Verify the power cable is securely connected to the drive, and the flat cable
is securely connected to the drive and to the SCSI connector on the system
board.
2. Verify all SCSI devices have unique IDs.
3. Ensure your SCSI device is not terminated.
4. Ensure connector pins are not displaced or distorted.

Replacing a Battery

If your HP Netserver repeatedly loses its configuration or the processor clock
stops, you should replace the battery.
WARNING
There is a danger of explosion if the battery is incorrectly
installed. For your safety, never attempt to recharge,
disassemble, or burn the old battery. Replace only with the
same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
1. Power down the HP Netserver and unplug power cord.
2. Gain access to the system board by following the appropriate instructions
for removing the chassis from the rack and removing the top cover.
110
Troubleshooting