Attaching Outer-Rails To The Rack - HP D5970A - NetServer - LCII Guía Del Usuario

Chapter 13
represents
the EIA unit
numbers on the
rack columns.
3rd Hole
From Bottom
1st Hole
From Bottom
Figure 13-3. Location Marks on the Rack's Columns
3. Mark the inside face of the left-rear and right-rear rack columns, with
masking tape, as shown in Figure 13-3.

Attaching Outer-Rails to the Rack

No tools are required to attach the outer-rail assemblies to the rack columns.
1. Pull the anti-tip foot forward out of the bottom of the rack.
See Figure 13-4 for the anti-tip foot location.
2. Lower the leveler screws on the rack's lower four corners to make firm
contact with the floor. See Figure 13-4.
3. Align the left outer-rail assembly to the left front and rear columns as
shown in Figure 13-4.
4. Match the outer-rail pins to the column holes (1st & 3rd) marked on the
front and rear columns. See Figure 13-3.
The mounting pins of the outer-rails should go into the inside face of the
rear column and front face of the front column.
118
Left
Masking
Side
Tape
Marker
Bottom of
HP NetServer
Alternative Rack Mounting (4–Post)
Rear of
Rack
Mark this face of
Right
the columns with
Side
masking tape
or marker pen.
Front of
Rack