HP D5970A - NetServer - LCII Guía Del Usuario page 111

Chapter 12
Table 12-1. POST Error Messages
Message
Operating
system not found
Keyboard error
(The LP 1000r
will complete the
boot process
without a
keyboard
connected.)
Mouse error
(The LP 1000r
will complete the
boot process
without a mouse
connected.)
If no message
appears (screen is
blank)
If a config-
uration error
occurs
Corrective Action
Verify the desired boot drive has power and its
SCSI cable connected.
Verify the SCSI cable is securely plugged into the
SCSI connector on the system board.
Verify the boot device is enabled in the Setup
Utility under the Security menu.
Verify the boot device has an operating system
installed.
If the problem persists, contact your HP support
organization.
Verify the keyboard is connected to the correct
connector (not the mouse connector) at the rear of
the Netserver.
Verify the connector is pushed completely.
If the problem persists, replace the keyboard or
contact your HP support organization.
Verify the mouse is connected to the correct
connector (not the keyboard connector) at the rear
of the Netserver.
Verify the connector is pushed completely.
If the problem persists, replace the mouse or
contact your HP support organization.
If no text or messages appear listen for the beep
codes. Refer to the beep codes listed in the HP
Netserver LP 1000r Service Manual.
If no message appears but the Netserver stops after
POST, verify the DIMMs are correctly installed.
If you suspect the BIOS is corrupted, refer to
"Clearing the CMOS Configuration," and restart
the Netserver.
If a Netserver configuration error is reported during the
startup routine, clear the CMOS memory as described
under "Clearing the CMOS Configuration," and restart
the Netserver.
Troubleshooting
105