HP D5970A - NetServer - LCII Guía Del Usuario page 8

Chapter 1
CD-ROM Eject Button
CD-ROM CD-ROM Activity LED
SCSI Disk ID 0
Figure 1-2. Input and Storage Device Controls
Table 1-1. Power Switch and Indicators
Control/Indicator
Power On/Off/Sleep
Switch
Push-button
Switch
On/Off/Sleep LED
LED
Reset Switch
RESET
Push-button
Switch
2
FDD Eject Button
RE S E T
FDD Activity LED
SCSI Disk ID 1
Description
This push-button switch turns the HP Netserver power On
or Off, and if available, also transitions the Netserver
between Power On and sleep states. If sleep states are not
available, then this button only turns power On or Off.
The sleep states are NOS dependent and not available if
your NOS does not support power management based on
the ACPI (Advanced Configuration and Power
Management Interface) standard. Refer to "Applying
Power to the HP Netserver" and "Sleep States (ACPI)"
later in this chapter.
This green LED provides the power state of the Netserver:
Steady Green when the Netserver is operating
normally
Blinking Green at 1-Hz rate indicates the Netserver
is in a sleep state and under ACPI control
Off (unlit) when the Netserver is powered off or in
standby
This push-button momentary switch creates a hard system
reset. This is the equivalent to a power-on reset.
Controls, Ports, and Indicators
Flexible Disk Drive
(FDD)
SCSI Disk ID 2