HP D5970A - NetServer - LCII Guía Del Usuario page 28

Chapter 3
6. Verify the tab on each ejector arm engages the edge of the drive bay as you
close it. See Figure 3-4.
You should feel each ejector arm click into place when it closes
completely. Closing both ejector arms engages the drive with the electrical
connector at the rear of the Hot Swap drive bay and seats the drive.
Locking tab pivots
when ejector arm
is opened or closed.
7. If the drive is unseated in the drive bay after closing both ejector arms,
repeat this procedure from Step 2 to 5.
The ejector arms may not have opened enough to engage the tab, or the
SCSI connector failed to engage the SCSI connector at the rear of the Hot
Swap drive bay.
NOTE
Closing both ejector arms will ensure the drive connector
engages the electrical connector in the Hot Swap drive bay and
seats the drive.
22
Drive Ejector Arms
Figure 3-4. Closing Drive Ejector Arms
Installing Mass Storage Devices
Closing
Ejector Arm