HP D5970A - NetServer - LCII Guía Del Usuario page 117

Chapter 12
Refer to Chapter 2, "Opening and Closing the HP Netserver," to gain
access to the system board.
3. If necessary, remove the PCI board to gain access to the battery.
See Figure 12-2.
4. Insert a small flat-blade screwdriver or similar tool between the battery
and spring latch. See Figure 12-3.
5. Push the spring latch away from battery to release the battery.
The spring contacts beneath the battery cause it to pop up allowing you to
grasp the battery.
6. Remove the existing battery.
View Roated
90 Degrees CCW
7. Insert the new battery with the positive sign (+) facing up in the socket.
8. Press down on the center of the battery with your thumb, pushing the
battery down into the socket.
The battery should snap into place.
Figure 12-3. Battery on System Board
Troubleshooting
111