Installing Additional Boards; Introduction; Tested Pci Boards; Tools Required - HP D5970A - NetServer - LCII Guía Del Usuario

5 Installing Additional Boards

Introduction

The HP Netserver LP 1000r provides one 64-bit PCI slot connected to a riser
board on the system board, which will handle a full-length 32-bit or 64-bit PCI
accessory board.

Tested PCI Boards

For a list of tested PCI boards, check for compatibility in Configuration Assistant
on the Navigator CD-ROM or look for the Hardware Tested Products list for the
HP Netserver LP 1000r under the Service and Support topic for the specific NOS
used in the Netserver at HP's web site:
http://www.hp.com/netserver/support/
CAUTION
NOTE
Also refer to the Readme file and Configuration Advisor on your HP Netserver
Navigator CD-ROM. Refer to Chapter 10, "Configuring the HP Netserver," for
instructions.

Tools Required

The following tools are only needed when removing or adding an accessory board
in the HP Netserver:
An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.
Some accessory board outputs may exceed U.S. National
Electrical code (NFPA 70) Class 2 or limited power source
limits and must use appropriate interconnecting cabling in
accordance with the National Electrical Code.
All Hewlett-Packard accessory boards comply with the U.S.
National Electrical code (NFPA 70) Class 2.
35