Post Error Messages - HP D5970A - NetServer - LCII Guía Del Usuario

Chapter 12
5. Replace the cover and connect all cables.
6. Turn on the monitor and Netserver.
7. If the Netserver still does not work:
Repeat steps 1, 2, and 3 of this section.
Remove all accessories, except the primary boot hard disk drive.
Replace the cover and connect all cables.
Turn on the monitor and the Netserver.
If the Netserver now works, replace the boards and accessories one at a
time to determine which one is causing the problem.
8. If the Netserver still does not work contact your service representative to
replace the Netserver.

POST Error Messages

If you get a POST text error message in reverse video, press the [Enter] key
(View System Error) to get a more detailed explanation and a possible solution.
If the Netserver starts, but POST still reports an error message, clear the CMOS
configuration, as described later in this chapter.
NOTE
HP recommends you correct the error before proceeding, even
if the Netserver appears to start successfully.
Table 12-1 describes the typical POST text error messages and the corrective
action you may take to remedy the problem.
104
Troubleshooting