HP D5970A - NetServer - LCII Guía Del Usuario page 11

Chapter 1
The Video Port interface specifications are listed in Table A-4, "HP
Netserver Hardware Specifications" and Table A-5, "Video Display
Modes" of Appendix A, "Specifications."
The two LAN ports (LAN A/MGMT and LAN B) are for embedded
controllers based on Intel's 82559 10/100 BaseT Fast Ethernet controller.
Only LAN A/MGMT is used with Alert-on-LAN 2 (AOL2) and Wake-on-
LAN remote management functions. Each one has a RJ-45 LAN
connector and two LEDs to indicate LAN speed and valid connection.
Refer to Table 1-3 for the LAN LED indicators and Chapter 10,
"Configuring the HP Netserver."
The external SCSI port provides access to external SCSI devices, typically
an external SCSI tape back-up device.
Power Mouse
Keyboard USB (2)
Table 1-3. LAN Port (RJ45) LED Indicators
Indicator
Link LED
LAN Speed Indicator
Parallel
LAN A/MGMT
Serial A/MGMT Video
Figure 1-3. Rear Panel and Ports
Definition
This green LED is the activity/link indicator.
Steady On indicates a valid LAN link.
Flashing On indicates there is LAN activity.
This yellow LED is the LAN speed indicator.
Steady Off indicates the LAN is operating at
10 Mbps LAN speed.
Steady On indicates the LAN is operating at
100 Mbps LAN speed.
Controls, Ports, and Indicators
LAN B PCI Slot (1)
External
SCSI Connector
5