Removing Dimms - HP D5970A - NetServer - LCII Installation Manual

Chapter 5
Figure 5-3. Inserting a DIMM into a Connector
8. Repeat step 2 to install all of the DIMMs for your memory configuration.
9. If you are not installing any other options, replace the top cover. See
Chapter 3, "Opening and Closing the HP NetServer LPr."
NOTE Most DIMMs are dimensionally identical, so if you have three
or more DIMMs installed, you may check that they are all
seated by sliding a straight edge (a pen for example) across
their top edges and checking that it remains in continuous
contact with all of the DIMMs.

Removing DIMMs

You may need to remove a DIMM module to downsize your memory
configuration or to replace a defective DIMM.
1. Log off all users. Back up files. Follow instructions in your network
operating system (NOS) documentation to gracefully shut down all
networking software and applications.
2. Press the power switch on the HP NetServer's control panel when
prompted by the operating system.
3. Disconnect the power cables and signal cables and, if necessary, label
them to support reassembly.
34
Installing Additional Memory
DIMM
Notches
Keys
Retaining Clips