HP D5970A - NetServer - LCII Installation Manual page 50

Chapter 7
Figure 7-2. Remove PCI Card Access Panel
6. Apply pressure at the top of the PCI access cover to pop it out.
7. Read the documentation that is included with the PCI card. Note any
special instructions.
NOTE
Adding a PCI-to-PCI bridge card to the HP NetServer may
alter the server's boot order. This boot order can be changed
using the SETUP utility (press [F2] during the boot process).
Refer to Chapter 4, "Installing Mass Storage Devices," and see
the subsection, "Boot Device Priority."
8. Identify the PCI slot number to be used.
42
Installing Additional Boards