Install The Processor Module - HP D5970A - NetServer - LCII Installation Manual

Hp netserver lpr installation guide
Hide thumbs Also See for D5970A - NetServer - LCII:
Table of Contents

Advertisement

Chapter 8
2. Check the processor clock switch settings and determine the clock
speed of the primary processor module now on the system board.
Figure 8-2. Processor Module Switch Settings
3. Check your upgrade kit to ensure that the additional processor module
supports the same or higher clock rate.
NOTE
If you have two modules in your system with different clock
rates, the switch setting must be for the lower of the two.
4. If necessary, use a miniature screw driver to reset the processor clock
switch.

Install the Processor Module

CAUTION
The processor module is sensitive to static electricity and can
be easily damaged by improper handling. Do the following
when handling the accessory kit:
54
Leave the processor module in the anti-static container
until you are ready to install it.
Use an anti-static wrist strap and a grounding mat.
Before you remove a processor module from the anti-static
container, touch a grounded, unpainted metal surface on
the HP NetServer LPr to discharge static electricity.
Installing Additional Processors

Advertisement

Table of Contents
loading

Table of Contents